TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 874 of 968

TM 9-2815-210-34-2-2

6-4. CONNECTING ENGINE TO DYNAMOMETER,

NOTE

In order to join engine to the dynamometer,

it may be necessary to use different types of

adapters or fittings other than shown. If

fittings are not available, tell machine shop to

make them.

1.

Take out oil gage rod (1).

2.

Put two hose clamps (2) on outlet hose (3).

3.

Put one end of outlet hose (3) on engine water outlet (4) and other end on

test stand return tube (5).

Push two hose clamps (2) to ends of outlet

hose and tighten.

4.

Put two hose clamps (2) on inlet hose (6).

5.

Put one end of inlet hose (6) on engine water inlet (7) and other end on test

stand supply tube (8).

Push two hose clamps (2) to ends of inlet hose and

tighten them.

GO TO FRAME 2

6-19