TM-9-2815-220-24
AVDS-1790 2CA, 2DA and 2DR Air-Cooled 12-Cylinder Diesel Engines
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL FOR AVDS-1790 2CA, 2DA and 2DR Air-Cooled 12-Cylinder Diesel Engines
TM-9-2815-220-24 - Page 1263 of 1563
TM 9-2815-220-24
DAMPER/OIL FILTER HOUSING ASSEMBLY REPLACE/REPAIR
0151 00
THIS WORK PACKAGE COVERS:
WP 0151 00-1
Removal, Disassembly, Cleaning, Inspection, Repair, Assembly, and Installation
INITIAL SETUP:
Tools and Special Tools:
Four leg sling (item 105, WP 0176)
General mechanic’s tool kit (item 121, WP 0176)
Torque wrench, 0-300 inch-pounds
(item 124, WP 0176)
Torque wrench, 500-2500 inch-pounds
(item 128, WP 0176)
Mandatory Replacement Parts:
Gasket (item 105, WP 0175)
Gasket (item 331, WP 0175)
O-ring (item 142, WP 0175)
O-ring (2)(item 145, WP 0175)
O-ring (3)(item 148, WP 0175)
Pipe plug (1) (item 255, WP 0175)
Pipe plug (1) (item 276,WP 0175)
Pipe plug (2) (item 278, WP 0175)
Pipe plug (4) (item 56, WP 0175)
Pipe plug (5) (item 170, WP 0175)
Self-locking nuts (2) (item 33, WP 0175)
Self-locking nuts (16) (item 34, WP 0175)
Expendable Materials:
Lubriplate (item 23, WP 0173)
Sealing compound, silicone sealant
(item 33, WP 0173)
Personnel Required:
Track Vehicle Repairer (2) 63H10
Equipment Conditions:
Wiring harness removed (for 2CA use
WP 0057), (for 2DA use WP0058), (for 2DR
use WP 0059)
Engine on maintenance stand (WP 0130)
Fans, covers, and top deck removed (WP 0054
and WP0055)
Throttle control solenoid assembly and
associated parts removed (WP 0125, WP 0126
and WP 0123)
Fuel/water separator bracket assembly removed
(WP 0164)
Heater fuel filter mounting bracket removed
(WP 0166)
2CA, 2DA: Pump drive adapter assembly
removed
(WP 0110)
Manifold heater pump, fuel back flow valve,
brackets and lines removed (WP 0081)
Manifold heater solenoids and lines removed
(WP 0088)
Fuel/water separator drain cock and lines
removed (WP 0084)
2CA, 2DA: Engine installation guides removed
(WP 0132)
2DR: Power take-off housing and associated
parts removed (WP 0111)
Engine and transmission oil coolers and lines
removed (WP 0072)
Oil cooler frames and shrouds removed
(WP 0090)
Breather tube removed (WP 0078)
Oil lines to turbo and fuel injection pump
removed (WP 0078)
Back to Top
