TM-9-2815-220-24
AVDS-1790 2CA, 2DA and 2DR Air-Cooled 12-Cylinder Diesel Engines
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL FOR AVDS-1790 2CA, 2DA and 2DR Air-Cooled 12-Cylinder Diesel Engines
TM-9-2815-220-24 - Page 26 of 1563
TM 9-2815-220-24
HOW TO USE THIS MANUAL
viii
WHAT'S IN THE MANUAL - FRONT TO BACK (Continued)
Chapter 9
contains Supporting Information:
References
(WP 0172) lists forms, publications, supply catalogs, engine accessory and
vehicle technical manuals and other documentation used by personnel.
Expendable and Durable Items List
(WP 0173) lists
expendable supplies and materials
identified in the INITIAL SETUP section of the work package.
The list is in alphabetical
order.
Torque Limit Tables
(WP 0174) includes special and standard torque limits for fasteners,
studs, and pipe plugs.
Mandatory Replacement Parts List
(WP 0175) lists mandatory replacement parts
identified in the INITIAL SETUP section of the work package.
The list is in part number
(not alphabetical nomenclature) sequence.
Tool Identification List
(WP 0176) lists tools and equipment identified in the INITIAL
SETUP section of the work package. The list is in alphabetical order.
Illustrated List of Manufactured Items
(WP 0177) provides directions to locally
fabricate tools, fixtures, or other items needed to maintain or repair the engine.
Disassembly/Assembly Procedure Sequence for the AVDS 1790-2 Engine
(WP 0178) lists the procedures to disassemble and then to assemble the engine.
This is
presented in a table which lists the work package number.
Abbreviations and Glossary
(WP 0179) defines abbreviations and unusual terms found in
the manual.
Alphabetical Index
lists major engine and container parts repaired or replaced at the
Organizational, Direct Support or General Support level.
Each entry in the index includes
the work package number.
DA Form 2028
is used to report an error found in this manual.
Metric Conversion Chart
(last page) converts U.S. measurements to metric equivalents.
Measurements in the work packages are given in both U.S. and metric units.
CONFIGURATION DIFFERENCES
Configuration differences between engine models are covered in the work packages as they
occur.
When the difference between models is significant there will be a separate work
package for each model.
DA FORM 2407
A DA Form 2407 will accompany any faulty engine. Before you repair a faulty engine, review
the DA Form 2407 that came with it.
One or more fault symptoms will be described on the
form.
You will use the fault symptoms and the Quick Guide to Troubleshooting (WP 0005) to
determine which work package to use for a given fault.
Back to Top
