TM-9-2815-220-24
AVDS-1790 2CA, 2DA and 2DR Air-Cooled 12-Cylinder Diesel Engines
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL FOR AVDS-1790 2CA, 2DA and 2DR Air-Cooled 12-Cylinder Diesel Engines
TM-9-2815-220-24 - Page 28 of 1563
TM 9-2815-220-24
HOW TO USE THIS MANUAL
HOW TO USE WORK PACKAGES
The following is an example of the "
INITIAL SETUP"
section in a maintenance work package.
Not every work package will have all of the categories listed; only those that apply will be there.
TM 9-2520-220-24
INTAKE AND EXHAUST VALVE CLEARANCE ADJUSTMENT
0034 00
THIS WORK PACKAGE COVERS:
Before Adjustment, Adjustment, and After Adjustment
INITIAL SETUP:
Tools:
General mechanic’s tool kit (item 121, WP 0176)
Torque wrench, 0-300 inch-pounds (item 124, WP 0176)
Manufactured Items:
Engine (flywheel)
turning tool, 2DR only (item 4, WP
0177)
Mandatory Replacement Parts
:
Gasket (2) (item 350, WP 0175)
Expendable Materials:
Lubriplate (item 23, WP 0173)
Personnel Required:
Track Vehicle Repairer (2) 63H10
Equipment Conditions:
Cooling fans, vane housings, and fan
housing removed (WP 0054)
LEGEND
TITLE:
Identifies the name and number of the work package.
THIS WORK
PACKAGE
COVERS
Describes the overall actions to be performed (remove, disassemble, adjust,
assemble, install, etc.).
Tools:
This is a list of the tools and equipment you will need. Part number and national
stock number of each tool can be found in the referenced work package.
Tools
found in the general mechanic’s tool kit are not listed separately.
Expendable
Materials:
These supplies are needed to perform the work package.
Manufactured
Items:
These are items that have to be manufactured or fabricated in order to do the
work package.
The referenced work package describes how to do this.
Mandatory
Replacement
Parts:
The parts listed are those you must replace every time the work package is
performed.
Use the Repair Parts and Special Tools List (RPSTL)
TM 9-2815-220-24P to order the parts you need for the work package.
Personnel
Required:
This tells you the person authorized to perform the work package.
Equipment
Conditions:
Describes the condition the equipment must be in before you start the work
package.
Each condition is followed by a work package reference.
Use this
reference to find the work package that sets up that equipment condition.
NOTE
:
When you go to the referenced work package, you mush also perform
the Equipment Conditions on that referenced work package.
x
Back to Top
