TM-9-2815-237-34

ENGINE, DIESEL: 8 CYLINDER, 6.2 AND 6.5, NORMALLY-ASPIRATED, DETUNED AND TURBOCHARGED

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

JULY 2004

CHANGE 2

TM-9-2815-237-34 - Page 118 of 267

TM 9-2815-237-34

2-32. FUEL INJECTION PUMP REPAIR (Cont’d)

5.

6.

7.

8.

9.

10.

Apply sealing compound to outside diameter of pilot tube (4).

Using pilot tube mandrel, install pilot tube (4) in housing (5) until groove (6) in pilot tube (4) aligns

with vent hole (7) in housing (5).

Using drive shaft bearing installer, install drive shaft bearing (3) in housing (5). Go to step 11.

Inspect drive shaft bearing (3) for roughness or damage. If rough or damaged, perform steps 9

and 10. If not, go to step 11.

Remove drive shaft bearing (3) from housing (5) and discard bearing (3).

Using drive shaft bearing installer, install driveshaft bearing (3) in housing (5).