C 1, TM 9-2920-242-35
CHAPTER 5
INTRODUCTION
Section I. GENERAL
42. Scope
a.
The procedures covered in this change will
apply only to those models listed on the title page of
this change (page 47). Because of earlier erroneous
identification, it is suggested the reader firmly fix
in his mind the fact that the basic manual should
have been labeled Delco-Remy 1113904-B and not
1113904 as indicated on basic manual.
b.
The starters covered in this change are im-
proved models incorporating new armatures and
solenoid relays.
Although the starters differ
internally from the earlier models, they are all to be
replaced by military model 10911018-1 (para 43,
below).
43. Differences Between Models
a.
Military part No. 10911018-1 was originally
assigned to Delco-Remy Model 1113904-B starter.
Improvements were made to this model and it was
later designated as Delco-Remy model 1113943, and
still identified as military part No. 10911018-1.
The nose housing on these two models are indexed to
37 degrees 30 minutes for the Mack ENDT-673
and LDS-465-1A engines, and 52 degrees 30 minutes
for the LDS-465-1 engine.
b.
Military part No. 10911018 identifies Delco-
Remy Model 1113904 starter. This starter is
similar to Delco-Remy model 1113943 except for the
nose housing which is indexed 82 degrees, 30 minutes
clockwise of the solenoid relay. This starter is used
on engine model LD-465-1.
c.
Military part No. 10911018-1 also identifies
Delco-Remy model 1113944. This starter is similar
to models 1113904 and 1113943 except that the
pinion gear contains one blank tooth. This starter
is used on engine model V8-300 only. The nose
housing is indexed at 47 degrees, 30 minutes clock-
wise of the solenoid relay.
Section Il.
DESCRIPTION AND DATA
44. Description
45. Data
Refer to paragraph 4 for description of starter,
Refer to paragraph 5 for tabulated data on starter,
part No. 10911018 and 10911018-1.
part No. 10911018 and 10911018-1.
51