TM-9-3990-260-14-P

CONTAINER ROLL-IN/OUT PLATFORM (CROP) MODEL M3 AND MODEL M3A1

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

JULY 2001

TM-9-3990-260-14-P - Page 103 of 306

TM 9-3990-260-14&P

Table 4-1. Unit Maintenance Preventive Maintenance Checks and Services -Continued

Item

No.

Interval

Location

Item to

Check/Service

Procedure

Not Fully Mission

Capable If:

5

Semi-

Annually

End Structure

Assembly

a.

Ensure two front (14) and rear pins

(15) are not bent, galled, cracked, cor-

roded, or stripped so they do not seat

properly or cannot be sufficiently tight-

ened.

a.

Front or rear pin(s)

bent, galled, cracked,

corroded, or stripped so

they do not seat properly

or cannot be sufficiently

tightened.

b.

Visually inspect all welds and par-

ent material for cracks.

b.

Parent material or

weld is cracked.

c.

Ensure end structure assembly

tubular frame (16) is not bent, prevent-

ing it from loading correctly on a PLS

truck.

c.

End structure

assembly tubular frame

is bent, preventing

CROP from loading cor-

rectly on PLS truck.

6

Semi-

Annually

Rollers

a.

Inspect exterior of roller (17) to

ensure it is not broken or so defaced that

it does roll properly.

b. Inspect center roller next to shaft to

ensure it is not worn more than 1/4 inch

(6.4 mm) between bushing and roller

material (if bushing is not present).

a.

Roller is broken or

so defaced that it does

not roll properly.

b. Center of roller

exceeds wear criteria.

c.

Ensure shaft (18) is straight, with all

hardware attached.

c.

Shaft is bent so

roller will not roll or

hardware is missing so

roller can detach.