TM-9-3990-260-14-P
CONTAINER ROLL-IN/OUT PLATFORM (CROP) MODEL M3 AND MODEL M3A1
TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
JULY 2001
TM-9-3990-260-14-P - Page 119 of 306
TM 9-3990-260-14&P
Change 1
5-1
CHAPTER 5
DIRECT SUPPORT MAINTENANCE
(M3 CROP)
Para
Contents
Page
5-1
Common Tools and Equipment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-1
5-2
Special Tools, TMDE and Support Equipment
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-1
5-3
Repair Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-1
5-4
Service Upon Receipt . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-1
5-5
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-2
5-6
Additional Inspection Criteria
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-2
5-7
General Welding Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-5
5-8
Deck Plate Replacement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-9
Section I.
REPAIR PARTS, SPECIAL TOOLS, TEST, MEASUREMENT
AND DIAGNOSTIC EQUIPMENT (TMDE) AND SUPPORT EQUIPMENT
For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment (MTOE)
applicable to your unit.
Refer to Appendix B, the Maintenance Allocation Chart (MAC) and Appendix F, Repair Parts and Special Tools
List (RPSTL), to determine special tools, TMDE and support equipment for the M3 CROP. No fabricated tools are needed.
Repair parts are listed and illustrated in the Repair Parts and Special Tools List (RPSTL), Appendix F, covering Unit and
Direct Support Maintenance for the M3 CROP.
Section II.
SERVICE UPON RECEIPT
Chapter 4 contains service upon receipt instructions. Specific paragraphs are referenced for additional instructions.
a.
Unpacking.
Refer to paragraph 4-4a.
b.
Servicing.
Refer to paragraph 4-4b.
5-1.
COMMON TOOLS AND EQUIPMENT.
5-2.
SPECIAL TOOLS, TMDE AND SUPPORT EQUIPMENT.
5-3.
REPAIR PARTS.
5-4.
SERVICE UPON RECEIPT.
Back to Top
