MWO-5-2350-262-35-4

ARMORED COMBAT EARTHMOVER (ACE), M9

MODIFICATION WORK ORDER

MWO-5-2350-262-35-4 - Page 178 of 207

MWO 5--2350--262--35--4

B--3

APPENDIX B

HULL/EJECTOR INTERFERENCE MODIFICATION -- CONTINUED

WHEEL SUPPORT WEDGE PROCEDURE

WARNING

Do not operate ejector when personnel are in bowl. Do not stand or work in bowl unless

ejector lock is engaged. Do not stand in bowl to observe roller guide travels. Failure to

comply may result in serious injury or death to personnel.

a. Preface surface on both sides of bowl area where wheel support wedges, 12488668, (1) will be welded.

b. Position wedge (1) against side of bowl. Grind as necessary to ensure snug fit against side of bowl.

c.

Using a straight edge, align top of wedge (1) with surface of bowl as shown below.

d. Weld wheel support wedge in place in accordance with standard welding guidelines.

Figure B--3. Right and Left side Wheel Support Wedge Locations

Figure B--4. Wheel Support Wedge Welded in Position

Straight Edge

1