MWO-5-2350-262-35-4

ARMORED COMBAT EARTHMOVER (ACE), M9

MODIFICATION WORK ORDER

MWO-5-2350-262-35-4 - Page 179 of 207

MWO 5--2350--262--35--4

B--4

APPENDIX B

HULL/EJECTOR INTERFERENCE MODIFICATION -- CONTINUED

a. Remove rear floor plates per TM--5--2350--20--1.

WARNING

Ejector cylinder weighs 325 lb (148 kg). Support ejector cylinder with blocks or straps

while it is being moved. Do not put hands or feet under ejector cylinder while it is being

moved.

b. Remove ejector cylinder bracket (1) per TM--5--2350--20--1.

1

Figure B--5. Ejector Cylinder Bracket Removal

c.

Install spacer block, 12488667, (2) and bracket (3) on hull with four flat washers, MS9320--16, (4) and new hex

head cap screws, B1821BH063C375L, (5). Tighten screws to 123--135 lb--ft (167--183 N

D

m).

3

4

5

2

Figure B--6. Spacer Block Installed

d. Install bracket (3) to rear ejector cylinder end per TM--5--2350--20--1.

e. Install rear floor plates per TM--5--2350--20--1.