TB-9-2300-378-14
M48 & M60 SERIES VEHICLES
TECHNICAL BULLETIN; AIR INDUCTION SYSTEM MAINTENANCE
SEPTEMBER 1985
TB-9-2300-378-14 - Page 83 of 296
TB 9-2300-378-14
(1) Parts Required. Table 4-3 lists the parts required to fabricate the ground hop
filter.
Table 4-3. Ground Hop Filter Parts
Nomenclature
Filter element
Hose assembly (on engine)
1/4" thick x 13-7/8" dia.
aluminum plate
5/16" dia. x 45-1/2" long
cold rolled steel rod
1/16" thick x 5-3/4" dia.
rubber sheet
3/8" washer, plain
Chain (11 inches)
1/4" 20 x 3/4 screws
1/4" washer, plain
5/16" 18 wing nut
1/8" welding rod
Part No.
11604545
11655240
MS27183-15
MS35275-281
MS27183-10
MS35425-39
NSN
Qty
2
2
2
4
2
12
2
12
12
8
As Req’d
(2) Retainer (4 required). Fabricate as follows:
(a) Using steel rod, bend to dimensions (view A).
(b) Using 5/16-18 die, thread each rod end a minimum of 2 inches.
(3) Gasket (2 required).
Using 1/16 rubber sheet, fabricate gaskets as described in
view B.
(4) Handle (2 required).
Using length of chain welding rod and washer, fabricate
chain end as follows:
(a) Bend 1/8 inch welding rod to shap (view C).
(b) Weld rod to edge of washer on one side.
(c) Install chain.
4-23
Back to Top
