TB-9-2320-279-13-P-2

TECHNICAL BULLETIN; CREW PROTECTION KIT

OPERATOR’S, UNIT AND DIRECT SUPPORT MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL)

SEPTEMBER 2005

TB-9-2320-279-13-P-2 - Page 148 of 460

TB 9-2320-279-13&P-2

REAR CAB (LEFT) ARMOR REPLACEMENT - CONTINUED

0026 00

0026 00-4

INSTALLATION - CONTINUED

4.

Using lifting device, install left-rear cab armor (16) on vehicle.

5.

Position four brackets (13) over edge of window opening.

6.

Tighten 12 locknuts (4) and bolts (14) to 108 lb-in. (12 Nm).

7.

Install spacer (5), roof bracket (10), four washers (7), bolts (6), eight washers (8), and new locknuts (9).

8.

Install two armored washers (17), washers (19), bolts (18), washers (20) and new locknuts (21) on left-rear cab armor

(16).

9.

If equipped with 4-point seat belts, install seat belt bracket (15), three washers (12), and new locknuts (11) (NSN 5310-

01-466-2695).

10.

Apply bead of sealant between rear cab armor and window opening on inside of cab.

11.

If equipped, install C4ISR brackets (WP 0040 00).

END OF WORK PACKAGE