TB-9-2320-279-13-P-2

TECHNICAL BULLETIN; CREW PROTECTION KIT

OPERATOR’S, UNIT AND DIRECT SUPPORT MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL)

SEPTEMBER 2005

TB-9-2320-279-13-P-2 - Page 142 of 460

TB 9-2320-279-13&P-2

REAR CAB (RIGHT) ARMOR REPLACEMENT - CONTINUED

0025 00

0025 00-2

REMOVAL - CONTINUED

3.

Slide tire carrier (1) away from rear window.

4.

If equipped with 4-point seat belts, remove three locknuts (14), washers (15), and seat belt bracket (18). Discard lock-

nuts.

5.

Install lifting link, sling, and lifting device in center hole of right-rear cab armor (13).

6.

Remove 12 locknuts (9), washers (10), bolts (11), and washers (12) from right-rear cab armor (13). Discard locknuts.

7.

Loosen 12 bolts (16) and remove four brackets (17) from rear window opening.

WARNING

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-

dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of

heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-

sonnel.

NOTE

Rear cab (right) armor weighs 100 lb (46 kg).

8.

Using lifting device, remove right-rear cab armor (13) from vehicle.

9.

Remove lifting device, sling, and lifting link from right-rear cab armor (13).