TB-9-2320-279-13-P-2

TECHNICAL BULLETIN; CREW PROTECTION KIT

OPERATOR’S, UNIT AND DIRECT SUPPORT MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL)

SEPTEMBER 2005

TB-9-2320-279-13-P-2 - Page 425 of 460

II

106700-7

Rev. -

Page 67

m.

Install the 10 bolts (5/16 – 18 x 1.250 LG), 10 lockwashers (5/16 ID), and

10 flat washers (5/16 ID) through the 10 holes in the passenger side of the Roof

Armor Panel.

Hand-tighten the bolts.

NOTE

Use shims (P/N 106796) on the mounts between the Rear Cab Armor Panel and the

Roof Armor Panel Rear Bracket (P/N 106736-1) (See Figure 42).

n.

Install four bolts (3/8 – 16 x 1.500 LG) and four washers (3/8 ID) through the Rear

Cab Armor Panel from inside of the cab.

p.

Place Spacer (P/N 106796-1) over the exposed threads of the four previously

installed bolts (3/8 – 16 x 1.500 LG).

r.

With the Roof Armor Panel in place, remove the locknuts loosely securing the

Rear Studplate (P/N 106780-2) to the Roof Armor Panel.

s.

Install the Roof Rear Bracket (P/N 106736-1) over the exposed studs of the

Rear Studplate (P/N 106780-2) and over the four bolts with a shim through the

Rear Cab Armor Panel (See Figure 42).