TB-9-2320-279-13-P-2
TECHNICAL BULLETIN; CREW PROTECTION KIT
OPERATOR’S, UNIT AND DIRECT SUPPORT MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL)
SEPTEMBER 2005
TB-9-2320-279-13-P-2 - Page 52 of 460
TB 9-2320-279-13&P-2
OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) - CONTINUED
0009 00
0009 00-6
6
Before
Side Armor
(Right Side)
a. Inspect side armor panels and door
assembly for damage or loose or
missing mounting hardware.
Any side armor panel or door assembly
is damaged or mounting hardware is
loose or missing.
b. Inspect exterior surface of door ballis-
tic glass for pitting, cracks, or
scratches.
Pitting, cracks, or scratches exist in the
exterior layer of door ballistic glass and
penetrate through to the inner layer.
c. Open door and enter cab. Close door
using grab handle. Lock door with
lock pin. Make sure door closes with-
out binding and locks correctly (WP
0004 00).
Door binds or does not lock.
d. Ensure door ballistic glass can open,
close, and securely lock.
Door ballistic glass will not close or
lock.
e. Inspect interior surface of door ballis-
tic glass and windshield ballistic glass
for pitting, cracks, or scratches.
Pitting, cracks, or scratches exist on the
interior surface of the door ballistic
glass or windshield ballistic glass.
f. If dirty, clean door ballistic glass (WP
0010 00).
ITEM
NO.
INTERVAL
LOCATION
PROCEDURE
NOT FULLY MISSION
CAPABLE IF:
ITEM TO
CHECK/
SERVICE
Back to Top
