TB-9-2320-279-13-P-2
TECHNICAL BULLETIN; CREW PROTECTION KIT
OPERATOR’S, UNIT AND DIRECT SUPPORT MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL)
SEPTEMBER 2005
TB-9-2320-279-13-P-2 - Page 54 of 460
TB 9-2320-279-13&P-2
OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) - CONTINUED
0009 00
0009 00-8
END OF WORK PACKAGE
NOTE
An indication of rear cab mount failure is evidence of wear or rubbing on
side door above driver-side or passenger-side blast deflector.
9
Weekly
Rear Cab
Mounts
Inspect rear cab mounts for evidence of
deterioration, overcompression, or loose
mounting hardware. Notify your super-
visor of any damage or looseness found.
10
Weekly
Wheels and
Wheel Rims
Inspect wheel lug nuts and wheel rim
bolts/nuts for looseness (e.g., polished
surface, rust, or minor cracks around
bolt and wheel mating surfaces). Notify
your supervisor of any looseness found.
Two or more studs or nuts are missing
from the same wheel.
11
Weekly
Armor Kit
Mounting
Hardware
Check all armor kit mounting hardware
for loose or missing hardware. Notify
your supervisor of any loose or missing
mounting hardware found.
12
Weekly
Escape
Hatch
a. Check that escape hatch is centered in
roof opening and securely latched
closed. Ensure there is no damage to
latches and latch mounting hardware.
Escape hatch will not latch closed.
b. Inspect for damage to escape hatch
seal. Notify your supervisor of any
damage found.
13
Weekly
Door
Assemblies
and Straps
Check both door assembly seals, hard-
ware, and stop strap for damaged or
loose components. Notify your supervi-
sor of any damage found.
14
Weekly
Center Blast
Deflector
Check center blast deflector for evi-
dence of contact with steering compo-
nents. Notify your supervisor of any
contact points found.
ITEM
NO.
INTERVAL
LOCATION
PROCEDURE
NOT FULLY MISSION
CAPABLE IF:
ITEM TO
CHECK/
SERVICE
Back to Top
