TB-9-2320-279-13-P-3

TECHNICAL BULLETIN; TANKER ARMOR MODULE KIT

OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST AND INSTALLATION INSTRUCTIONS)

JANUARY 2007
TB-9-2320-279-13-P-3

  TB-9-2320-279-13-P-3 - Page 10 of 396

TB 9-2320-279-13&P-3
iv
CONTENTS OF THIS TECHNICAL BULLETIN - CONTINUED
f.
Chapter 4,
Field Maintenance Instructions
includes all field maintenance tasks.
g.
Chapter 5,
Supporting Information
, includes
References; Maintenance Allocation Chart
(MAC)
Introduction
;
Maintenance Allocation Chart (MAC); Expendable and Durable Items List; Torque Limits; Tanker Armor
Module Kit Installation Instructions; Repair Parts and Special Tools List (RPSTL) Introduction
; and
Repair
Parts and Special Tools List (RPSTL)
.
FEATURES OF THIS TECHNICAL BULLETIN
a.
WARNINGs, CAUTIONs, NOTEs, subject headings, and other important information are highlighted in
BOLD
print as a visual aid.
WARNING
A WARNING indicates a hazard which may cause injury or death to personnel.
CAUTION
A CAUTION is a reminder of safety practices or directs attention to usage practices that may
cause damage to equipment.
NOTE
NOTE
A NOTE is a statement containing information that will make the procedures easier to
perform.
b.
Statements and words of particular interest may be printed in CAPITAL LETTERS to create emphasis.
c.
Within a procedural step, reference may be made to another work package in this technical bulletin or to
another manual. These references indicate where you should look for more complete information.
1.
If you are told: “Refer to
Tanker Armor Module Kit Installation Instruction
(WP 0040),” go to WP 0040 in
this technical bulletin for instructions on this procedure.
2.
If you are told; “For complete information on HEMTT Operator PMCS, refer to TM 9-2320-279-10,” go to
References
in WP 0032 for complete information on the cited reference.
d.
Illustrations are placed after, and as close to, the procedural steps to which they apply. Callouts placed on the
art are text or numbers.
e.
Technical instructions include metric units as well as standard units. For your reference, a
Metric Conversion
Chart
is located on the inside back cover of the technical bulletin.
END OF WORK PACKAGE


Back to Top