5-81
TB 9-2320-280-35-13
Figure 5-99.
6
7
11
8
9.75
EPLRS MOUNTING PLATE
9
10
~
NOTE
• Remove left rear side rail, if necessary.
(Refer to TM 9-2320-280-20.)
• Rear edge of upper mounting plate should be approximately
1.187 in. from front edge of EPLRS mounting plate.
25-3.
Locate screw (7) on left rear wheelhouse (11), and drill out rivet (8) from left rear wheelhouse (11).
Enlarge hole to 0.281 in.
25-4.
Position support plate underneath wheelhouse (11) and drill two 0.281-in. diameter holes.
25-5.
Using upper antenna plate (6) as template, locate, mark, and drill nine 0.281-in. holes (9) and
three 0.408-in. holes (10) in left rear wheelhouse (11).
6. ANTENNA PLATE – A3104004-1 – QTY. 1
9
9