TB-9-2320-280-35-13
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR SINGLE CHANNEL GROUND AND AIRBORNE RADIO SYSTEM (SINCGARS) AN/VRC-88F, AN/VRC-89F, AN/VRC-90F, AN/VRC-91F, AN/VRC-92F
OCTOBER 2006
CHANGE 1
TB-9-2320-280-35-13 - Page 97 of 148
5-69
TB 9-2320-280-35-13
20. LOOP CLAMP – MS21333-112 – QTY. 3
22. LOOP CLAMP – MS21333-69 – QTY. 3
26. NUT – 9419143 – QTY. 1
28. LOOP CLAMP – MS21333-98 – QTY. 1
29. CAPSCREW – B1821BH025C075N – QTY. 1
Figure 5-89.
22-7.
Route SINCGARS antenna cable (11) down B-pillar (19) to cab enclosure panel (23).
22-8.
Locate, mark, and drill one 0.281-in. hole (27) in right overcab mount (2).
22-9.
Secure right-side SINCGARS antenna cable (11) to overcab mount (2) with clamp (28),
screw (29), and nut (26).
NOTE
Clamps will be large to accommodate speaker cables installed in
Section XXIX.
22-10.
Secure SINCGARS antenna cable to B-pillar (19) with three clamps (20) and existing screws (21).
22-11.
Secure SINCGARS antenna cable (11) to cab enclosure panel (23) with three clamps (22) and
existing screws (29).
22-12.
Route SINCGARS antenna cable (11) under integrated rack (25), up through access hole, and to
vicinity of SINCGARS mount.
~
~
19
20
21
22
24
2
~
25
~
2
26
27
28
29
11
~
23
Back to Top
