TB-9-2320-302-13-P-2

CREW PROTECTION KIT PART 2 OF 3

TECHNICAL BULLETIN; OPERATOR'S, UNIT AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS AND REPAIR PARTS AND SPECIAL TOOLS LIST

JUNE 2007

TB-9-2320-302-13-P-2 - Page 220 of 396

ArmorWorks

x#

Be sure to power-off and secure all power sources of the vehicle. At no

time should any power be left on in the vehicle. Make sure all communi-

cation and electrical equipment is powered off.

x#

Remove negative battery terminal before installation.

x#

You must inspect the vehicle before installation for flammable material

to avoid risk of fire. Inspect for oily or wet substances that may be flam-

mable.

x#

Installation should be done in an area reasonably clean and free of

flammables. Be sure to avoid installing above an oily floor.

x#

This installation is best done in a spacious environment. Materials will

be placed along each side of the vehicle prior to the installation. There

is a risk of a trip hazard if the space is too confined.

x#

Use protective eyewear.

x#

To avoid injury while lifting some of the bulkier items, it is suggested to

use 2 or more individuals.

x#

Bolts attached to armor should be inspected and tightened every 3,000

miles.

x#

Torque until flat washers are compressed.

DO NOT OVERTIGHTEN

.

S

AFETY

TB 9-2320-302-13&P-2

0038 00-8