TB-9-2320-302-13-P-2
CREW PROTECTION KIT PART 2 OF 3
TECHNICAL BULLETIN; OPERATOR'S, UNIT AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS AND REPAIR PARTS AND SPECIAL TOOLS LIST
JUNE 2007
TB-9-2320-302-13-P-2 - Page 4 of 396
TB 9-2320-302-13&P-2
b
NOTE
For information on first aid, refer to FM 4-25.11.
Use caution when using adhesives and sealants. Prolonged inhalation of vapors can cause lung irritation.
Contact with skin can cause dermatitis. Wear gloves and safety goggles and use product in a well-ventilated
area away from open flame. If ingested, keep individual calm and seek medical attention. DO NOT induce
vomiting. If contact with skin or eyes is made, flush thoroughly with water. Dispose of cleanup rags IAW
local policy and ordinances. Failure to follow this warning may cause injury to personnel.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure when
drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning components. DO NOT
direct compressed air against human skin. Make sure air stream is directed away from user and other person-
nel in the area. To prevent injury, user must wear protective goggles or face shield. Failure to follow this
warning may result in injury or death.
Eye protection is required when drilling and when using riveter to install rivets. Failure to follow this warn-
ing may cause injury to personnel.
When servicing this vehicle, performing maintenance or disposing of materials such as engine coolant,
hydraulic fluid, lubricants, battery acids or batteries, and CARC paint, consult your unit/local hazardous
waste disposal center or safety office for local regulatory guidance. If further information is needed, please
contact The Army Environmental Hotline at 1-800-872-3845.
WARNING
ADHESIVES AND SEALANTS
WARNING
COMPRESSED AIR
WARNING
DRILLING AND RIVETING
WARNING
HAZARDOUS WASTE
WARNING
HEAVY COMPONENTS
Back to Top
