TB-9-2320-302-13-P-2
CREW PROTECTION KIT PART 2 OF 3
TECHNICAL BULLETIN; OPERATOR'S, UNIT AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS AND REPAIR PARTS AND SPECIAL TOOLS LIST
JUNE 2007
TB-9-2320-302-13-P-2 - Page 5 of 396
TB 9-2320-302-13&P-2
c
•
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during
procedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep
clear of heavy parts supported only by lifting device. Failure to follow this warning may cause injury or
death to personnel.
•
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during
procedure. Failure to follow this warning may cause injury or death to personnel.
•
Cab assembly with armor kit installed weighs 3,520 lb (1598 kg). Use hoist with lifting capacity of 4,000 lb
(1816 kg) to support cab assembly. Failure to follow this warning may cause injury or death to personnel.
•
Use caution when handling window glass. Glass can break unexpectedly during removal/installation
procedure. Wear face shield, apron, and gloves. Failure to follow this warning may cause injury to per-
sonnel.
•
Edges of metal armor panels may be sharp. Wear protective gloves when handling armor panels. Failure
to follow this warning may cause injury to personnel.
•
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition. Failure to follow this
warning may cause injury to personnel.
•
Improper cleaning methods and use of unauthorized cleaning solvents may injure personnel and damage
equipment. Refer to TM 9-247,
Materials Used for Cleaning, Preserving, Abrading, and Cementing
Ordnance Materiels and Related Materiels Including Chemicals
, for correct information.
•
Fire extinguishers should be placed nearby when using solvent cleaning compound.
•
Cloths or rags saturated with solvent cleaning compound must be disposed of IAW authorized facilities’
procedures.
•
Eye shields must be worn when cleaning with a wire brush. Flying rust and metal particles may cause
injury.
WARNING
THREAT PROTECTION
For proper threat protection, ballistic glass must be correctly installed onto ballistic glass frame. During
installation, ensure that decal “INSTALL THIS SURFACE TOWARDS THREAT” is located on outside of
cab. Improperly installed ballistic glass will not protect occupants. Failure to follow this warning may cause
injury or death to personnel.
WARNING
SHARP EDGES
WARNING
SOLVENT CLEANING COMPOUND
Back to Top
