TB-9-2320-335-13-P
TRUCK, UTILITY: EXPANDED CAPACITY, IAP/ARMOR READY
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE AND REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL) INSTRUCTIONS
MAY 2008
TB-9-2320-335-13-P - Page 173 of 680
TB 9-2320-335-13&P
6-9
6-7. HALFSHAFT MAINTENANCE (Cont’d)
1.
Pack outer joint (8) with lithium grease.
2.
Install outer boot (6) on shaft (7). Ensure boot (6) seats in groove of shaft (7).
3.
Secure outer boot (6) on shaft (7) with clamp (4).
4.
Install outer boot (6) on joint (8). Ensure boot (6) seats in groove of joint (8).
5.
Secure outer boot (6) on joint (8) with clamp (5).
6.
Clamp shaft (7) in soft-jawed vise.
7.
Position clamps (3) and (2) on shaft (7).
8.
Install inner boot (1) on shaft (7). Push boot (1) past groove on shaft (7).
e. Assembly
1
2
3
4
5
6
7
8
NOTE
When installing wear sleeve over halfshaft spline, ensure wear
sleeve does not come into contact with splines.
Using a pipe or like item (11.4), slide wear sleeve (11.3) over halfshaft spline (11.2) until flange (11.5) of
wear sleeve (11.3) contacts shoulder adjacent to halfshaft seal surface (11.1).
d. Wear Sleeve Installation
11.1
11.2
11.3
11.4
11.5
2.063 IN.
(52.4 MM) I.D.
6.00 IN.
(152.4 MM
Back to Top
