TB-9-2350-277-40-P-4

CARRIER, COMMAND POST, FULL-TRACKED, ARMORED, M577A3; STANDARD INTEGRATED COMMAND POST SYSTEM (SICPS), M1068A3

TECHNICAL BULLETIN; INSTALLATION OF CREW II MODIFICATION KIT PART 4 OF 4

JUNE 2009
TB-9-2350-277-40-P-4

  TB-9-2350-277-40-P-4 - Page 15 of 100

TB 9-2350-277-40&P-4
INTRODUCTION
0001 00
0001 00-1
PURPOSE
The purpose of this technical bulletin (TB) is to provide instructions and guidance on the method of
modifying the M1068A3 Standard Integrated Command Post System and M577A3 Command Post
Carrier for CREW II.
It further provides instruction on the installation of the CREW II modification kit
P/N 12498005.
The CREW II modification kit provides mounting for the next generation of improvised
explosive device (IED) jammers.
The modular CREW II “plug and play” design, allows the main line
replaceable unit (LRU), FRF105C dual antenna, and the remote control unit (RCU) to be utilized by
any Heavy Brigade Combat Team (HBCT) vehicle.
The M1068A3 and M577A3 locations were
chosen to provide the least impact on mission requirements, for example the command post
integrated systems computer equipment must retain full operator access and operational capability.
GENERAL
1.
Priority.
This bulletin is classified NORMAL.
2.
End item(s) to be modified.
This TB applies to the M577A3, Full-Tracked Armored Command
Post Carrier, 2350-01-369-6085, P/N 8750286 and M1068A3, Standard Integrated Command
Post System (SICPS), 2350-01-369-6086, P/N 8750288.
3.
Module(s) (components, assemblies, subassemblies, boards, and cards) to be modified.
Not
applicable.
4.
Parts to be modified.
Not applicable.
5. Application.
a. Time compliance schedule.
Not applicable.
b.
Lowest level of maintenance authorized to apply this modification.
The lowest level of
maintenance authorized to perform installation described by this TB is Sustainment.
c.
Work force and man-hour requirements for application of the modification to a single unit, end
item, or system.
A mechanic and helper require approximately 5 man-hours to install.
d.
Modifications to be applied to or concurrently with the application of this kit.
Not applicable.
e.
Additional information deemed necessary to assist in the application of this modification.
Kit
application will be concurrent with other depot overhaul/conversion programs, as applicable.
6.
Technical publications affected/changed.
The installation will be supported by TM 9-2350-277
series technical manuals with the upcoming Change 6.


Back to Top