TB-9-2350-277-40-P-4
CARRIER, COMMAND POST, FULL-TRACKED, ARMORED, M577A3; STANDARD INTEGRATED COMMAND POST SYSTEM (SICPS), M1068A3
TECHNICAL BULLETIN; INSTALLATION OF CREW II MODIFICATION KIT PART 4 OF 4
JUNE 2009
TB-9-2350-277-40-P-4 - Page 8 of 100
TB 9-2350-277-40&P-4
ii
TABLE OF CONTENTS
WP Sequence No.
Page No.
WARNING SUMMARY
CHAPTER 1 – GENERAL INFORMATION
Introduction.
....................................................................................................................
0001 00
Table 1.
Kit List .
.................................................................................
0001 00-2
Table 2.
Retained Parts .
....................................................................
0001 00-2
Table 3.
Excess Parts to be Discarded.
.............................................
0001 00-3
Table 4.
Parts Required (Not Furnished With Kit) .
............................
0001 00-3
Equipment Description .
..................................................................................................
0002 00
Figure 1.
CREW II Hardware .
............................................................
0002 00-2
Figure 2.
Location of CREW II Mounting Components.
.....................
0002 00-4
CHAPTER 2 – MAINTENANCE INSTRUCTIONS
Removal Procedures.
.....................................................................................................
0003 00
Figure 1.
Intercom Unit Removal (M1068A3 Only).
...........................
0003 00-1
Figure 2.
APU Controller Mounting Hardware Removal.
...................
0003 00-2
Figure 3.
Extension Cover Tent Angle Bracket Mounting
Hardware Removal .
..........................................................
0003 00-3
Modification Procedures.
................................................................................................
0004 00
Figure 1.
CREW II Primary Unit Clearance Provision .
......................
0004 00-2
Figure 2.
Locate and Mark CREW II Cable Port.
...............................
0004 00-3
Figure 3.
Location for CREW II Cover Plate.
.....................................
0004 00-4
Figure 4.
Location for CREW II Primary Unit Enclosure Mounting
Bracket.
.............................................................................
0004 00-5
Figure 5.
Location for Intercom Unit (M1068A3 Only).
......................
0004 00-6
Figure 6.
Location for CREW II Hull Roof RCU and GPS Cable
Clamp.
...............................................................................
0004 00-7
Figure 7.
Location for CREW II Right Rail Support Bracket
RCU and GPS Cable Clamps.
..........................................
0004 00-8
Installation Procedures.
..................................................................................................
0005 00
Figure 1.
SINCGARS Antenna Removal .
..........................................
0005 00-2
Figure 2.
Antenna Cover Removal.
....................................................
0005 00-3
Figure 3.
GPS Sensor, Mounting Bracket, and Cable Installation.
....0005 00-4
Figure 4.
GPS Cable Sealant Application.
.........................................
0005 00-5
Figure 5.
SINCGARS Antenna Installation .
.......................................
0005 00-6
Figure 6.
Antenna Cover Installation .
................................................
0005 00-7
Figure 7.
Crew II Antenna Stowage Bracket Installation .
..................
0005 00-8
Figure 8.
Cable Port Installation.
........................................................
0005 00-9
Figure 9.
Cable Port Sealant Application.
..........................................
0005 00-10
Figure 10.
Primary Unit Enclosure Assembly Installation.
.................
0005 00-11
Figure 11.
Primary Unit Enclosure Cover Installation.
.......................
0005 00-12
Back to Top
