TB-9-2510-251-13

TECHNICAL BULLETIN

OPERATOR AND FIELD MAINTENANCE; INSTALLATION MANUAL (INCLUDING REPAIR PARTS LIST); FOR ADD-ON-ARMOR (AoA) AIR CONDITIONING

AUGUST 2007

TB-9-2510-251-13 - Page 139 of 624

2-123

TB 9-2510-251-13

2-1.4

Installation of Air Conditioning Kit to M1025A2 with GSIE Add-on-Armor (Cont’d).

b. Install Evaporator and Condenser (Cont’d)

(10)

Loosely attach upper clamp brackets (9) to upper support brackets (10) on evaporator

unit (11) with four bolts (12), flat washers (13), and locknuts (14).

12

13

9

11

14

10

Figure 2-188.

Clamp Brackets

13

13

13

13

12

11

Figure 2-189.

Install Evaporator Unit

(11)

Remove two lower center 1/2 inch bolts from rear center armor plate and rear side armor

plates.

(12)

Hang evaporator unit (11) from inside top of armor plate (above holes drilled in

transmission tunnel).

(13)

Adjust evaporator unit (11) to align slots in lower support bracket (12) with slots in center

armor plate.

(14)

Close hatch and check for handle interface with top of evaporator unit.

(15) Tighten evaporator unit top clamp bracket bolts (13).