TM-10-5411-233-13-P

CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER

TECHNICAL MANUAL; OPERATOR’S, UNIT, AND DIRECT SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

SEPTEMBER 2002

TM-10-5411-233-13-P - Page 109 of 356

TM 10-5411-233-13&P

CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER

0013 00

UNIT MAINTENANCE

0013 00-5

Marking the location of the carrier mounting angle holes.

The bottom edge of the lower section of the

Cargo Bed Cover is attached to the vehicle bed by means of a series of carrier mounting angles

(1)

.

These angles and threshold have a total of 27 predrilled mounting holes where only 19 of the holes

(2)

are used.

To transfer the position of the carrier mounting holes to the vehicle bed, use the 3/8 inch transfer punch

(3)

supplied with the mounting kit and mark the vehicle bed in 19 places. There are 4 holes each in the

carrier mounting angles at the front

(4)

, left

(5)

, and right sides

(6)

of the CBC. There are two holes in

each of the two smaller carrier mounting angles

(7)

at the rear of the CBC located on either side of the

door opening and a total of 3 holes in the threshold.

Once all 19 hole positions have been marked, the CBC can be removed from the vehicle bed and

returned to its shipping pallet while the holes are drilled in the vehicle bed and Rivnuts installed.

3.0 inches

+/- .13

Front of

inside bed

Vehicle cab

4

M35A2

Truck Bed

5

2

1

NOTE:

Only those carrier

mounting angle holes

indicated on this drawing

by a short arrow on the

inside of the CBC require

drilling. The additional 8

holes shown on the side

carrier mounting angles

DO NOT

require drilling

and Rivnut installation.

Center line

of CBC and

Vehicle

Bed

Cargo Bed

Cover Lower

Section

3

6

7