TM-3-1040-279-12-P

GENERATOR SET, SMOKE, MECHANICAL: PULSE JET, M157 W/120 GAL FOG OIL TANK AND W/80 GAL FOG OIL TANK

TECHNICAL MANUAL; OPERATOR’S AND ORGANIZATIONAL MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST AND DEPOT MAINTENANCE REPAIR PARTS

MAY 1987

TM-3-1040-279-12-P - Page 132 of 389

TM 3-1040-279-12&P

4-16

EQUIPMENT CONTAINER ASSEMBLY (CONT).

Equipment Container.

REMOVAL

equipment container (8) and frame assembly (9). Remove brackets.

1.3

Remove eight screws (10), eight lock washers (11), eight washers (12), four spacers (13), and shims

(14) securing equipment container (8).

2.

Disconnect fuel hose (15) from nozzle assembly (16).

3.

Disconnect start air hose (17) from nozzle assembly (16).

4.

Disconnect purge air hose (18) from equipment container (8).

5.

Disconnect fog oil tube (19) from equipment container (8).

1.2

Remove eight screws (4), sixteen washers (5), and eight nuts (6) securing angle brackets (7) to

1.

Disconnect vehicle cable and hoses from smoke generator.

1.1

Remove eight screws (1) and washers (2) from both equipment container side panels (3) and

remove panels.

6.

Disconnect cable assembly W12 (20) from connector 5 J2 on equipment container (8).

7.

Disconnect ignition cable (21) from pulse jet engine (22).

8.

Remove equipment container (8) from frame assembly (9).

INSTALLATION

1.

Position equipment container (8) in frame assembly (9).

2.

Connect ignition cable (21) to pulse jet engine (22).

3.

Connect start air hose (17) to nozzle assembly (16).

4.

Connect cable assembly (20) to equipment container (8).

5.

Connect fog oil tube (19) to equipment container (8).

6.

Connect purge air hose (18) to equipment container (8).

7.

Connect fuel hose (15) to nozzle assembly (6).

8.

Install angle brackets (7) to equipment container (8) and frame assembly (9) with eight screws (4),

sixteen washers (5), and eight nuts (6). Do not fully tighten screws at this time.

4-68

Change 2