TM-5-2350-262-20-3
ARMORED COMBAT EARTHMOVER (ACE), M9
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL; VOLUME 3 OF 3; HYDRAULIC TROUBLESHOOTING TEST PROCEDURES
TM-5-2350-262-20-3 - Page 10 of 319
•
Ensure hydraulic pressure is relieved after ejector cylinder is pushed forward.
Pressure
may build up and cause the ejector to retract.
Failure to comply may result in severe injury
to personnel.
•
Hot exhaust systems can cause serious burns.
Do not work on or near hot exhaust
system components unless exhaust system is cool.
Failure to comply may result
in injury
to personnel.
•
Ensure stop is in locked position to prevent any movement of ejector control valve plunger,
or ejector can move.
Failure to comply may result in severe injury to personnel.
•
Do not breathe nitrogen gas.
Failure to comply may result in death to personnel.
•
Hot hydraulic oil can cause serious burns.
Pump and fittings must be cool to touch before
working on hydraulic system.
Failure to comply may result in severe injury to personnel.
•
Wear face shield or goggles for eye protection when using wire brush.
Failure to comply
may result in injury to personnel.
•
Ensure personnel are clear of bilge pump area before starting engine.
Failure to comply
may result in injury to personnel.
•
High pressure is present in the M9 hydraulic system.
Do not disconnect any hydraulic
system component unless hydraulic system pressure has been relieved.
Ensure each
hydraulic control lever is moved several times through all positions, and hydraulic tank
dipstick is slowly loosened to relieve pressure.
Failure to comply may result in severe
injury to personnel.
•
Protective plates and hull access covers may be heavier than they appear due to
accumulation of fluid and dirt.
Take extra precautions when removing access covers.
Failure to comply may result in severe injury or death to personnel.
•
Wear face shield or goggles for eye and face protection when removing and installing
hoses
from bottom of hydraulic tank.
Failure to comply may result in injury to personnel.
WARNING - CONTINUED
c (d blank)
TM 5-2350-262-20-3
Back to Top
