TM-5-2350-262-20-3
ARMORED COMBAT EARTHMOVER (ACE), M9
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL; VOLUME 3 OF 3; HYDRAULIC TROUBLESHOOTING TEST PROCEDURES
TM-5-2350-262-20-3 - Page 16 of 319
v
TM 5-2350-262-20-3
10.
On page 3-36, steps relating to resolving the problem of apron not raising are listed in the
form of a flow chart.
11.
Just answer the questions on the left hand page and follow the YES or NO path.
Helpful
information about the question is also on the right hand page.
12.
The procedures presume a basic working knowledge of the equipment to be used, but
references are included for less experienced personnel.
13.
At this point the diagnostic flow chart will direct you to a specific detailed procedure to solve
the problem.
NOTE
: Before attempting to repair or replace any hydraulic component you must:
(a)
Determine the maintenance responsibility for repair or replacement of the component.
(b)
If the task is at your echelon of maintenance responsibility, you must identify the tools
needed and
the replacement parts required.
Refer to the Maintenance Allocation Chart - MAC to determine not only the maintenance
responsibility of the item, but also to obtain an estimate of the time required to perform the
task, tools needed, and any
special notes/requirements necessary.
Refer to TM 5-2350-262-24P, Unit Direct Support and General Support Maintenance Repair
Parts and
Special Tools List for requisition data concerning replacement parts for this task.
Back to Top
