TM-5-2350-377-13-P

ARMORED COMBAT EARTHMOVER (ACE), M9

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST SUPPORTING THE HYDRAULIC BLADE FOLDER-TRACK TENSIONER

JUNE 2012
TM-5-2350-377-13-P

  TM-5-2350-377-13-P - Page 103 of 404

FIELD MAINTENANCE
TROUBLESHOOTING PROCEDURES - BLADE WILL NOT FOLD OR UNFOLD IN SPRUNG MODE
INITIAL SETUP:
Tools and Special Tools
Tool Kit, General Mechanic's: Automotive
(WP
0071, Table 1, Item 7)
Parts Kit, Hydraulic (WP
0071, Table 1, Item 4)
Personnel Required
Construction Equipment Repairer, 91L (Two)
References
TM 5-2350-262-10
References (cont.)
WP
0008
WP
0012
WP
0018
WP
0042
WP
0045
Equipment Condition
Hydraulic pressure relieved (TM 5-2350-262-20)
TROUBLESHOOTING PROCEDURE
HYDRAULIC INSTALLATION
NOTE
•
This work package contains information on locating faults and causes of malfunctions
that may develop in the M9 ACE with HBF-TT system. An alphabetical listing of symptoms
is provided, as well as a symptom index.
•
Before you begin troubleshooting, make sure the defect is real. If possible, talk to the
operator or mechanic that reported the problem. Look for any other problems that could
cause the system or component to malfunction, such as a switch or lever in the wrong
position. Refer to Operation Under Unusual Conditions (WP
0008) for correct operating
procedures. Check fluid levels as shown in TM 5-2350-262-10.
•
Many faults can be located by a good visual inspection. Look for leaks, loose or corroded
connections, damaged controls, and loose or damaged linkages.
•
For specific hydraulic troubleshooting symptoms not found in this manual, refer to
TM 5-2350-262-20.
•
When working on the hydraulic system, follow the general hydraulic system repair
methods and refer to the general hydraulic system troubleshooting procedures.
•
When trying to isolate a fault, review the past maintenance record on the affected vehicle.
Although it doesn't happen often, an incomplete or poorly performed maintenance task
may lead to another problem.
•
Wherever the word "lubricate" appears, see Operator Preventive Maintenance Checks
and Service (PMCS) (WP
0018).
•
Malfunctions, test or inspections, and corrective actions are listed/indented according to
the heading at the top of each page.
•
No attempt should be made to fold or unfold blade in UNSPRUNG mode.
TM 5-2350-377-13&P
0016
0016-1


Back to Top