TM-5-2815-241-34-P

ENGINE, DIESEL NTC-290

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT, MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

MARCH 1987

TM-5-2815-241-34-P - Page 140 of 738

TM 5-2815-241-34&P

ROCKER ARM COVER INSTALLATION

INITIAL SETUP

Tools

Materials/Parts

Screwdriver, flat-tip, 1/4-inch

Socket, 9/16-inch, 3/8-inch drive

Wrench, torque, 0 to 50 ft lb

(0 to 70 N•m), 3/8-inch drive

Gasket

Lockwasher (five required)

Equipment Condition

Engine compression brake housing installed

(page 2-116).

ACTION

LOCATION

ITEM

REMARKS

3.

NOTE

Steps given are typical for all three rocker arm covers.

Only front rocker arm cover contains oil filler cap and crankcase breather.

1. Engine compression

brake housing (1)

2.

Rocker arm cover (3)

New gasket (2) and

rocker arm cover (3)

Five flat washers

(4) five new lock-

washers (5) and

five screws (6)

Crankcase breather

hose (7) and

clamp (8)

Put on.

Using 3/8-inch drive 9/16-inch socket and

0 to 50 ft lb (0 to 70 N•m) torque wrench,

screw in and tighten to 12 to 17 ft lb (16.8 to

23.8 N•m).

a. Put on.

b. Using 1/4-inch flat-tip screwdriver,

tighten clamp.

TASK ENDS HERE

2-118

TA 242410