TM-5-2815-241-34-P
ENGINE, DIESEL NTC-290
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT, MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
MARCH 1987
TM-5-2815-241-34-P - Page 146 of 738
TM 5-2815-241-34&P
WATER INLET HOUSING INSTALLATION
INITIAL SETUP
Tools
Materials/Parts
Extension, 6-inch, 1/2-inch drive
Handle, ratchet, 1/2-inch drive
Socket, 9/16-inch, 1/2-inch drive
Gasket, water inlet housing
Lockwasher (five required)
Wrench, torque, 0 to 150 ft lb (0 to
210 N•m), 1/2-inch drive
Equipment Condition
Water pump installed (page 2-121).
ACTION
LOCATION
ITEM
REMARKS
Right front of
cylinder block (1)
New water inlet
housing gasket (2),
water inlet housing
(3), five new lock-
washers (4), and
five screws (5)
a.
Position water inlet housing and gasket
on cylinder block.
b.
Using 1/2-inch drive 9/16-inch socket,
6-inch extension, and ratchet handle,
screw in five screws and lockwashers
until snug.
c.
Using 1/2-inch drive 9/16-inch socket,
6-inch extension, and 0 to 150 ft lb (0 to
210 N•m) torque wrench, torque to 30 to
35 ft lb (40.6 to 47.4 N•m).
TASK ENDS HERE
TA 242416
2-124
Back to Top
