TM-5-2815-241-34-P
ENGINE, DIESEL NTC-290
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT, MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
MARCH 1987
TM-5-2815-241-34-P - Page 155 of 738
TM 5-2815-241-34&P
OIL DIPSTICK TUBE INSTALLATION
INITIAL SETUP
Tools
Materials/Parts
Socket, 9/16-inch, 12-inch drive
Socket, 5/8-inch, 1/2-inch drive
Wrench, torque, 0 to 150 ft lb
(0 to 210 N•m), 1/2-inch drive
Gasket
Lockwasher, bracket
Lockwasher, oil dipstick tube (two required)
ACTION
LOCATION
ITEM
REMARKS
NOTE
Remove screw from oil cooler before installation of oil dipstick tube.
1.
Oil pan (1)
New gasket (2) oil
dipstick tube (3), two
new lockwashers (4),
and two screws (5)
a.
b.
2.
Oil cooler (6)
Screw (7), new
lockwasher (8)
and bracket (9)
a.
b.
Position gasket and oil dipstick tube on
oil pan and put in two screws with new
lockwashers and tighten until snug.
Using 1/2-inch drive 5/8-inch socket
and 0 to 150 ft lb (0 to 210 N•m) torque
wrench, torque to 30 to 35 ft lb (40 to
47 N•m).
Screw in.
Using 1/2-inch drive 9/16-inch socket
and 0 to 150 ft lb (0 to 210 N•m) torque
wrench, torque to 30 to 35 ft lb (40 to
47 N•m).
TASK ENDS HERE
TA 242422
2-133
Back to Top
