TM-5-3805-254-14-P-2
TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW, IHC MODEL F-5070 (CCE)
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT AND DEPT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS INFORMATION AND SUPPLEMENTAL MAINTENANCE INSTRUCTIONS)
JUNE 1980
TM-5-3805-254-14-P-2 - Page 102 of 894
MOTOR TRUCK SERVICE MANUAL
BODIES AND CABS
Well-seasoned wood should be used for filler block
construction.
LUBRICATION
There are a number of points on the cab where
periodic application of lubricant will increase the service
life of the parts as well as eliminate objectionable
squeaking.
New vehicles are properly lubricated at the factory
and before they are delivered to the customer.
After the
vehicle is placed in oper-
ation, regular lubricant intervals based on type of service
and road conditions should be established.
Thorough
lubrication at definite intervals will add greatly to the
service life of the vehicle and will reduce the overall
operating expense of the vehicle.
Following are points on the cab to be lubricated and
the type of lubricant to use.
Wipe off all lubrication points
before applying new lubricant.
When lubricating the
points, apply lubricant sparingly so as not to allow excess
lubricant to get on the operator’s clothing.
LUBRICANT POINT
LUBRICANT
Door Dovetail.
.......................................................
Lubricate with Stick Lubricant
Door Hinge Pins .
..................................................
Light Engine Oil
Door Lock Assembly and Remote Control .
..........
Lubriplate 110 or Equivalent
Door Latch Striker Plate .
......................................
Lubricate with Stick
Lubricant
Door Lock Cylinder.
..............................................
Lock Oil
Door Window Regulator, Gear Teeth,
Arm Pin and Slide .
.........................................
Lubriplate 110 or Equivalent
Seat Adjuster.
.......................................................
Lubriplate 110 or Equivalent
Hood Pivot Bar .
....................................................
Lithium 12- Hydroxy Stearate
EP Grease
Butterfly Type Hood Hinge, .
.................................
Light Engine Oil
FRONT END SHEET METAL
Fender
To Remove:
1.
Disconnect headlight and directional light
wiring.
2.
Remove fourteen bolts, lockwashers and
nuts securing fender to chassis.
3.
Lift off fender.
To Install:
To install fender, reverse the foregoing
procedure.
Fender and Splash Panel Assembly
To Remove:
1.
Raise hood.
2.
Remove four nuts securing wiring harness clips to
splash panel.
3.
Disconnect headlight and directional light wiring.
4.
Disconnect horn wire.
5.
Remove fender grommet.
6.
Pull headlight wiring through grommet opening.
7.
Remove bolts securing fender to front and rear
support braces.
8.
Lift off fender and splash panel as an assembly.
To Install:
Reverse the foregoing procedure for fender
and splash panel installation.
100
Back to Top
