TM-5-3805-254-14-P-2

TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW, IHC MODEL F-5070 (CCE)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT AND DEPT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS INFORMATION AND SUPPLEMENTAL MAINTENANCE INSTRUCTIONS)

JUNE 1980

TM-5-3805-254-14-P-2 - Page 628 of 894

TRUCK SERVICE MANUAL

SPRINGS

REMOVING EQUALIZER BEAM BUSHINGS

(With Equalizer Beam in Place on Vehicles)

Special tool equipment (SE-1931) is avail-

able which can be used to replace the equalizer

beam bushings without completely removing

the equalizer beam from the chassis.

The

SE-1931 tool can also be used to replace the

bushings with the equalizer beams removed.

Operating instructions are furnished with the

equipment.

ADAPTER CHART

Adapters which can be made locally from standard tubing for removing and installing rubber

bushings.

*Adapters to be used with sheave puller.

Adapter Size

Application

6.9 cm O.D x 7.6 cm Long

Torque Rod Bushing Remover

(2.75 in O.D x 3.0 in Long)

7.6 cm O.D x 7.6 cm Long*

Torque Rod Bushing Installer

(3.0 in O.D x 3.0 in Long)*

11.0 cm O.D x 10.2 cm Long

Equalizer Beam End Bushing Remover

(4.25 in O.D x 4.0 in Long)

11.4 cm O.D x 10.2 cm Long*

(4.5 in O.D x 4.0 in Long)*

Equalizer Beam End Bushing Installer

13.7 cm O.D x 25.4 cm Long

Equalizer Beam Center Sleeve Bushing

(5.38 in O.D x 10.0 in Long)

Remover and Installer RT-500

621