TM-5-3805-254-14-P-2

TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW, IHC MODEL F-5070 (CCE)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT AND DEPT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS INFORMATION AND SUPPLEMENTAL MAINTENANCE INSTRUCTIONS)

JUNE 1980

TM-5-3805-254-14-P-2 - Page 845 of 894

GEARS AND CASE

24. Locate and secure front bearing cap cover (F-l)

to drive gear bearing cap (F-7) with cap screws (F-4) and

lock washers (F-6). Torque cap screws fo 40 50 lbs. ft.

25. Place front transmission hanger over front

bearing cap and assemble end yoke or flange with dirt

flinger on hub of yoke or flange (A-2). Assemble drive

gear with pusher tool. Observe the same caution and

procedure used in step 15.

26. Assemble flat washer (A-4) and nut (A-5) to end

of main drive gear. Lock auxiliary in two gears and torque

drive gear nut to 500 550 lbs. ft.

27. Shift clutch collars (B-6 and B-16) back into

neutral and rotate drive gear to make sure all shafts turn

free.

28. Use pressure type oil can to force lubricant down

the oil holes and end slots of all floating gears on the

mainshaft to flush out the grease and insure initial

lubrication of over-running gears and bearings. Use

regular auxiliary lubricant

836