TM-5-3805-254-20-2

TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW, IHC MODEL F-5070 (CCE)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL VOLUME 2 OF 2

JANUARY 1988

TM-5-3805-254-20-2 - Page 594 of 971

TM 5-3805-254-20-2

REAR HUB AND BRAKEDRUM ASSEMBLY AND WHEEL BEARINGS - CONTINUED

ACTION

LOCATION

ITEM

REMARKS

NOTE

Steps given are typical for right and left front rear and rear rear hubs.

34

Spindle (5)

Rear hub (1) and

a Coat spindle with grease

brakedrum (6)

(LO 5-3805-254-12).

b With assistance, put on.

Make sure inner bearing is seated on

inner race (7) on spindle.

35

Outer bearing (8)

a Pack outer bearing and coat outer

bearing cup (9) with grease

(LO 5-3805-254-12).

b Put on.

36

Adjusting nut (10)

a Position with pin (11) facing out and

screw on and tighten until snug.

b While slowly turning rear hub (1),

torque to 50 ft lb (70 N.m) using 4-inch,

3/4-inch drive socket and 0 to 600 ft lb

(0 to 814 N.m) torque wrench.

c Loosen one-quarter turn using 4-inch,

3/4-inch drive socket and hinged

handle

TA244453

2-1199