TM-5-3805-264-13-P

TRUCK, DUMP, HEAVY, BODY M917A1 AND M917A2

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JUNE 2014

TM-5-3805-264-13-P - Page 165 of 660

Table 1.

Preventive Maintenance Checks and Services (PMCS) for M917A1, M917A1 with Material Control

System (MCS), M917A2, and M917A2 with MCS - Continued.

ITEM

NO.

INTERVAL

ITEM TO BE

CHECKED OR

SERVICED

PROCEDURE

EQUIPMENT

NOT READY/

AVAILABLE IF:

12

Annual

Decals and

Stencils

Check all decals and stencils to ensure legibility.

13

10,000

Miles or

Annual

Hydraulic

Reservoir

WARNING

To prevent burns, use caution when

removing fill cap of hydraulic reservoir when

hydraulic fluid is hot. Avoid contact with hot

hydraulic oil. Use extreme care when

draining hydraulic oil. Failure to comply may

result in personnel injury or death.

1. With dump body down and engine off, remove

magnetic drain plug from underside of reservoir

(Figure 2, Item 4). Drain hydraulic oil into a suitable

container, and dispose of in accordance with local

procedures.

2. Remove fill cap (Figure 2, Item 2). Remove strainer

from reservoir (Figure 2, Item 4) (WP 0067). Clean

strainer and reinstall.

3. Replace hydraulic oil filter element (WP 0063).

4. Clean drain plug and reinstall.

NOTE

Hydraulic reservoir capacity is 12.75 gal.

(48.2 l). DO NOT overfill.

5. Fill reservoir (Figure 2, Item 4) with lubricating oil

until level of fluid in sight tube (Figure 2, Item 1) is at

FULL mark as indicated on oil level decal

(Figure 2, Item 3). Install fill cap (Figure 2, Item 2).

TM 5-3805-264-13&P

0019

0019-7