TM-5-3805-264-13-P

TRUCK, DUMP, HEAVY, BODY M917A1 AND M917A2

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JUNE 2014

TM-5-3805-264-13-P - Page 413 of 660

DISASSEMBLY - Continued

NOTE

Perform Steps 19 through 26 to remove next sleeve.

19.

Remove retaining ring (Figure 13, Item 1) from barrel (Figure 13, Item 2).

Figure 13.

Retaining Ring Removal From Barrel.

NOTE

Wiper retainer and seal should come out as sleeve is extended a few inches. If not, apply a

three-inch strip of tape at a 45-degree angle to a cleaned section of sleeve. Retract and

again extend sleeve to remove wiper retainer and seal.

20.

Extend sleeve (Figure 14, Item 1) to expose wiper retainer (Figure 14, Item 3) and seal (Figure 14, Item 4).

Remove wiper retainer and seal from sleeve. Remove wiper (Figure 14, Item 2) from wiper retainer. Discard

wiper, wiper retainer, and seal. Remove tape from sleeve, if used.

Figure 14.

Wiper, Wiper Retainer, and Seal Removal.

TM 5-3805-264-13&P

0066

0066-9