TM-5-3895-371-24-P
BITUMINOUS DISTRIBUTOR BODY M918, MODEL D-63
TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL WITH REPAIR PARTS AND SPECIAL TOOLS LIST
MARCH 1981
TM-5-3895-371-24-P - Page 47 of 330
TM 5-3895-371-24 & P
b.
Disassembly.
Loosen set screw and remove lock arm (7), remove two nuts (6) and capscrews
(9) from handle (8) and remove handle. Drill out rivets (13) from hinge (11) and remove hinge from
lid (4).
C.
Assembly.
Install hinge (11) to lid (4) with five bolts (12) and nuts (10). Install handle (8)
and secure with two nuts (6) and capscrews (9). Install lock arm (7) and tighten set screw.
d.
Installation.
(Refer to fig. 2-4.)
(1)
Set stowage box (5) on rear frame rails and secure with six capscrews (3).
(2)
Position lid (4) on stowage box (5) and secure with five capscrews (2).
Section VIII. MAINTENANCE OF BELL
2-12. Bell.
a.
Removal.
(Refer to fig. 2-5.)
(1)
Loosen screw (1) and pull out lanyard (2).
LEGEND:
1.
SCREW
2. LANYARD
3. CAPSCREW (2)
4. BELL ASSEMBLY
5. STRIKER
6. ACTUATING ARM
TA
075809
Figure 2-5.
Remove/Install
Bell
Mechanism
and Lanyard.
2-24
Back to Top
