TM-5-3895-371-24-P
BITUMINOUS DISTRIBUTOR BODY M918, MODEL D-63
TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL WITH REPAIR PARTS AND SPECIAL TOOLS LIST
MARCH 1981
TM-5-3895-371-24-P - Page 37 of 330
TM 5-3895-371-24 & P
Section VI. MAINTENANCE OF ELECTRICAL SYSTEM
2-9. Loom Bumper and Marker Lamps.
NOTE
For ease in installation, check diagram
showing wire color code and terminal
location before removing wires in step
(2). (See fig. 2-2.)
a.
Removal.
(1)
Remove terminal board cover (40, fig. 2-1) by removing two capscrews (3) and lock-
washers (4).
(2)
Disconnect wires from terminal board (42).
(3)
Remove two screws (43) and remove terminal board (42).
(20).
(4)
Remove retaining ring (19), lens (18), and gasket (16) from right hand taillamp assembly
(5)
Depress bulb (17), turn counterclockwise, and remove.
(6)
Remove two nuts (8) and washers (7) from base (15). Cut electrical wires and remove
right hand taillamp assembly (20).
(30).
(7)
Remove retaining ring (19), lens (18), and gasket (16) from left hand taillamp assembly
(8)
Depress bulb (32), turn counterclockwise, and remove.
(9)
Remove two nuts (8) and washers (7) from base (33). Cut electrical wires and remove
left hand taillamp assembly (30).
(10)
Remove license lamp window (31) from base (33).
(11)
Remove two nuts (38), washers (39), capscrews (34), and bracket (35).
(12)
Remove two screws (27), lens rim (26), lens (25) and gasket (23).
2-14
Back to Top
