TM-5-3895-371-24-P
BITUMINOUS DISTRIBUTOR BODY M918, MODEL D-63
TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL WITH REPAIR PARTS AND SPECIAL TOOLS LIST
MARCH 1981
TM-5-3895-371-24-P - Page 28 of 330
TM 5-3895-371-24 & P
Table 2-1. ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES
(Continued)
Q-Quarterly
S-Semiannually
A-Annually
B-Biennially
H-Hours
M-Miles
ITEM
INTERVAL
ITEM TO BE INSPECTED
NO.
Q
S
A
B
H
Ml
PROCEDURE:
Check for and have
repaired, filled, or adjusted
as needed.
BURNER FUEL SYSTEM (Continued)
11
Check smoke stack cover spring for damage and check operation.
Replace spring if necessary.
BITUMETER WHEEL ASSEMBLY
12
13
Check air lines and fittings. If damaged, replace.
Check power line and ground on solenoid for corrosion and bare
wires, replace defective wires.
14
Check that bitumeter positions itself when activated. Adjust or
repair as needed.
SPRAY BAR
15
Check that spray bar positions itself whenever control switches are
activated. Adjust as needed.
16
17
Check chains. Replace as necessary.
Check power lines to solenoids for corrosion and bare wires. Replace
defective wires.
18
Check relation of quadrant lever position with nozzle lever position.
Adjust linkage as needed.
19
20
21
Check recording bitumeter cable operation and service it.
Check pump tachometer cable and service it.
Check air control reservoir. Open drain cock to let out condensation.
2-5
Back to Top
