TM-5-3895-372-34
CONCRETE-MOBILE MIXER BODY M919, MODEL 8CM-24/F
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
SEPTEMBER 1980
TM-5-3895-372-34 - Page 14 of 120
TM 5-3895-372-34
CHAPTER 2
DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE INSTRUCTIONS
Section I.
REPAIR PARTS, SPECIAL TOOLS, AND EQUIPMENT
2-1.
Special Tools and Equipment.
Special tools, and test and support equipment are listed in the Repair Parts and
Special Tools List covering Direct Support and General Support maintenance for this equipment (TM 5-3895-372-34P).
2-2.
Repair Parts.
Repair parts for the mixer body are listed in the Repair Parts and Special Tools List for Direct
Support and General Support maintenance (TM 5-3895-372-34P).
2-3.
Fabricated Tools and Equipment.
The specially designed tools and equipment illustrated in figures 2-1, 2-2, and
2-3, listed in table 2-1, are for Direct Support and General Support Maintenance personnel performing maintenance on the
mixer body.
The tools and equipment listed in table 2-1 are not available for issue, but must be fabricated by qualified
Direct Support and General Support maintenance personnel.
Table 2-1.
Fabricated Tools and Equipment
References
Item
NSN
Fig
Para
Use
Seal installation thimble
2-1
3-19
Installation of seals
(FSCM 81346)
in hydraulic motor
Seal installation sleeve
2-2
3-19
Installation of seals
(FSCM 81346)
in hydraulic motor
Shaft seal driver
*9510-0&228-6257
2-3
3-8
Installation of shaft seal
(FSCM 81346)
in hydraulic pump
*1.75 inch cold roll bar stock; C-1018; 18-20 feet long.
Do not harden after tool is fabricated.
Change 1
2-1
Back to Top
