TM-5-3895-372-34
CONCRETE-MOBILE MIXER BODY M919, MODEL 8CM-24/F
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
SEPTEMBER 1980
TM-5-3895-372-34 - Page 16 of 120
TM 5-3895-372-34
Figure 2-3.
Shaft Seal Driver.
Section II.
TROUBLESHOOTING
2-4.
Introduction.
Information on this chapter is for use of supporting maintenance personnel in conjunction with and
as a supplement to the troubleshooting procedures in TM 5-3895-372-20.
It provides a continuation of instructions given in
TM 5-3895-372-20.
WARNING
Operation of a deadlined vehicle without a preliminary examination can cause further damage to a
disabled component and possible injury to personnel.
By careful inspection and troubleshooting, such
damage and injury can be avoided.
In addition, the causes of faulty operation of a vehicle or component
can often be determined without extensive disassembly.
2-5.
Using the Troubleshooting Table.
Table 2-2 lists possible malfunctions of the mixer body which are covered in
this manual.
These malfunctions are grouped according to the mixer body system in which they occur.
Each malfunction
is followed by a list of steps you should take to find the cause of the problem.
When you have found the cause, perform
the corrective action listed under that step.
Change 1
2-3
Back to Top
