TM-5-3895-372-34
CONCRETE-MOBILE MIXER BODY M919, MODEL 8CM-24/F
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
SEPTEMBER 1980
TM-5-3895-372-34 - Page 39 of 120
TM 5-3895-372-34
Figure 2-11.
Remove/Install Winch Control Box Cover.
(10) Remove four capscrews and lockwashers (2, fig.
2-12).
Cut cable ties (1) and remove microswitch (3).
(11) Remove two bolts, nuts and lockwashers (1, fig.
2-13) and remove box (3) and wiring cable (2) from vehicle.
(12) Remove two hex bolts, lockwashers and nuts (1, fig.
2-14).
(13) Remove four hex bolts, lockwashers, and nuts (2).
(14) Remove one hex bolt, lockwashers, and nut (3).
(15) Remove frame (4).
(16) Remove left and right rear fender by removing twenty-one bolts, lockwashers and nuts on each fender.
NOTE
Removal of left and right side belt tensioning devices is identical.
Remove both tensional
2-26
Back to Top
