TM-5-3895-372-34
CONCRETE-MOBILE MIXER BODY M919, MODEL 8CM-24/F
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
SEPTEMBER 1980
TM-5-3895-372-34 - Page 50 of 120
TM 5-3895-372-34
2-15.
Main Clutch.
a. Removal.
(1) Remove two access covers (1, fig.
2-22).
(2) Clean, polish, and lubricate drive shaft (4, fig.
2-23) just forward of U-joint (3).
(3) Mark the rear U-joint (3) and drive shaft (4) on both ends of the U-joint to aid in reassemble.
The U-joint and
shafts are line drilled for roll pins during initial assembly and can only be assembled in one position.
(4) Remove two roll pins (2) and grease fitting from U-joint cross.
Figure 2-22.
Remove/Install Access Covers.
2-37
Back to Top
