TM-5-3990-263-13-P

PALLET, ADAPTER, BRIDGE, M15

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)

APRIL 2012
TM-5-3990-263-13-P

  TM-5-3990-263-13-P - Page 251 of 728

OPERATOR MAINTENANCE
WINCH ASSEMBLY WILL NOT WIND IN
INITIAL SETUP:
References
WP
0004
WP
0035
Equipment Condition
BAP loaded on vehicle. (WP
0005)
Engine started. (TM 9-2320-435-10 or TM
9-2320-425-10) (WP
0076)
Equipment Condition (cont.)
Parking brakes applied. (TM 9-2320-435-10 or
TM 9-2320-425-10) (WP
0076)
Wheels chocked. (TM 9-2320-435-10 or
TM 9-2320-425-10) (WP
0076)
TROUBLESHOOTING PROCEDURE
SYMPTOM
Winch Assembly will not Wind in.
MALFUNCTION
Winch Assembly Switch not Set Correctly.
CORRECTIVE ACTION
Ensure winch assembly switch on remote control unit is set to IN (Figure 1). (WP
0004)
REMOTE
CONTROL
UNIT
WINCH
ASSEMBLY
SWITCH
Figure 1.
Winch Assembly Switch.
a.
If winch assembly switch is not set correctly, set switch to IN position.
b.
If winch assembly switch is set correctly, proceed to next Malfunction.
TM 5-3990-263-13&P
0026
0026-1


Back to Top