TM-5-3990-263-13-P

PALLET, ADAPTER, BRIDGE, M15

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)

APRIL 2012

TM-5-3990-263-13-P - Page 455 of 728

FIELD MAINTENANCE

WINCH CABLE TENSIONER REPAIR

INITIAL SETUP:

Tools and Special Tools

Tool Kit, General Mechanics: Automotive

(WP

0078, Table 2, Item 2)

Materials/Parts

Gloves, Protective (WP

0081, Table 1, Item 8)

Pin, Cotter (WP

0082, Table 1, Item 4) Qty:

2

Locknut (WP

0082, Table 1, Item 3) Qty:

6

Locknut (WP

0082, Table 1, Item 2) Qty:

1

Personnel Required

(2)

References

Parts Manual (WP

0073, Figure 13)

Equipment Condition

Load removed from the BAP. (WP

0008)

Wheels chocked. (TM 9-2320-435-10 or

TM 9-2320-425-10) (WP

0076)

Winch cable fully extended. (WP

0008)

Engine turned off. (TM 9-2320-435-10 or TM

9-2320-425-10) (WP

0076)

REMOVAL

WARNING

•

Always wear protective gloves when handling winch cable. Never let cable run through

hands. Frayed cables can cut severely. Failure to comply may result in serious injury or

death to personnel.

•

Never operate winch with less than five wraps of cable on winch drum. Failure to comply

may result in serious injury or death to personnel.

•

Do not move the CBT until the bridge bay has been fully loaded into the water from the

vehicle. Failure to comply may result in serious injury or death to personnel.

1.

Remove two cotter pins (Figure 1, Item 1) and retainer bar (Figure 1, Item 2) from handle assembly (Figure 1,

Item 3) and base assembly (Figure 1, Item 4). Discard cotter pins.

TM 5-3990-263-13&P

0056

0056-1