TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

  TM-5-5420-202-20-2 - Page 573 of 734

TM 5-5420-202-20-2
FUEL TANK (RIGHT) REPLACEMENT (Sheet 6 of 15)
21.
Using 1/2 inch socket or 1/2 inch wrench,
remove
four
screws and
washers (AJ)
securing mount (AK) and bracket (AL) to hull.
CAUTION
Fuel tank is fabricated of aluminum and is
therefore subject to damage from sharp
objects. Use utmost care during handling.
Do not force tank with poles or bars as
damage may result.
During disassembly, several tank open-
ings may be exposed. Close these openings
with masking tape to prevent entry of
foreign matter.
22.
Using three persons, pivot fuel tank toward center
of hull while slowly moving fuel tank rearward
until rear end of fuel tank clears curve in hull.
Go on to Sheet 7
7-338
Change 5
NOTE
Flat lower front section of fuel
tank must be held horizontal while
under crew compartment floor to
avoid binding.


Back to Top